A network administrator is selecting a switch that will operate at the network core. Which three features should the switch support for optimum network performance and reliability? (Choose three.)

port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware  Power over Ethernet (PoE) ccna explorat...

For organizations that are implementing a voice over IP solution, what functionality should be enabled at all three layers of the hierarchical network?

Power over Ethernet quality of service switch port security inter-VLAN routing ccna exploration 3 chapter 1 Exam Question And Answers  For o...

At which heirarchical layer are switches normally not required to process all ports at wire speed?

core layer distribution layer access layer entry layer ccna exploration 3 chapter 1 Exam Question And Answers  At which heirarchical layer a...

Which hierarchical design characteristic would be recommended at both the core and distribution layers to protect the network in the case of a route failure?

PoE redundancy aggregation access lists ccna exploration 3 chapter 1 Exam Question And Answers  Which hierarchical design characteristic wou...

A network technician is asked to examine an existing switched network. Following this examination, the technician makes recommendations for adding new switches where needed and replacing existing equipment that hampers performance. The technician is given a budget and asked to proceed. Which two pieces of information would be helpful in determining necessary port density for new switches? (Choose two.)

forwarding rate traffic flow analysis expected future growth number of required core connections number of hubs that are needed in the acces...

Which two features are supported at all three levels of the Cisco three-layer hierarchical model? (Choose two.)

Power over Ethernet load balancing across redundant trunk links redundant components Quality of Service link aggregation ccna exploration 3 ...

Which layer of the OSI model does an access layer LAN switch use to make a forwarding decision?

Layer 1 Layer 2 Layer 3 Layer 4 ccna exploration 3 chapter 1 Exam Question And Answers  Which layer of the OSI model does an access layer LA...

Configuring communication between devices on different VLANs requires the use of which layer of the OSI model?

Layer 1 Layer 3 Layer 4 Layer 5 ccna exploration 3 chapter 1 Exam Question And Answers  Configuring communication between devices on differe...

What is the likely impact of moving a conventional company architecture to a completely converged network?

Local analog phone service can be completely outsourced to cost-effective providers. The Ethernet VLAN structure is less complex. A shared i...

Which three features are commonly supported at the distribution layer of the Cisco hierarchical network model? (Choose three.)

security policies Power over Ethernet switch port security quality of service Layer 3 functionality end user access to network ccna explorat...

Refer to the exhibit. Beginning with HR servers and workstations, a network engineer is designing a new security structure for the network. Which set of policies adheres to the hierarchical network model design principles?

Refer to the exhibit. Beginning with HR servers and workstations, a network engineer is designing a new security structure for the network. ...

Which hierarchical design model layer controls the flow of network traffic using policies and delineates broadcast domains by performing routing functions between virtual LANs (VLANs)?

application access distribution network core ccna exploration 3 chapter 1 Exam Question And Answers  Which hierarchical design model layer c...

Which feature supports higher throughput in switched networks by combining multiple switch ports?

convergence redundant links link aggregation network diameter ccna exploration 3 chapter 1 Exam Question And Answers  Which feature supports...

Which two characteristics are associated with enterprise level switches? (Choose two.)

low port density high forwarding rate high latency level support link aggregation predefined number of ports ccna exploration 3 chapter 1 Ex...

Which layer of the hierarchical network design model is refered to as the high-speed backbone of the internetwork, where high availability and redundancy are critical?

access layer core layer data-link layer distribution layer network layer physical layer ccna exploration 3 chapter 1 Exam Question And Answe...

Cisco Certification

Cisco is an excellent addition to any curriculum professionals. Get a Cisco Certification, you are demonstrating that you have learned a Cis...

Refer to the exhibit. The network administrator issues the command no ip classless on Router1. What forwarding action will take place on a packet that is received by Router1 and is destined for host 192.168.0.26?

Refer to the exhibit. The network administrator issues the command no ip classless on Router1. What forwarding action will take place on a p...

Refer to the exhibit. Which statement is true concerning the routing configuration?

Refer to the exhibit. Which statement is true concerning the routing configuration?  Using dynamic routing instead of static routing would h...

CCNA 4 Final Exam Answer

CCNA 4 Final Answer Set-1 1 Refer to the exhibit. Branch A has a non-Cisco router that is using IETF encapsulation and Branch B has a Cisco ...